How Should a Waxing Treatment Be Performed?

Wax Warmer should be placed on a stable surface.

Place a roll on top of the wax-filled bottles, then put them in the warmer for 30–45 minutes and cover them with a lid.

This procedure should be performed on clean, dry skin.It is not recommended to take a bath for at least 2 hours before the procedure.

Degrease the leather with rubbing alcohol or a similar fast-evaporating solution (an antiseptic solution may also be used) and wait until the leather is dry.

After that, it's best to use talcum powder and spread a thin layer over the entire area to be shaved.After removing the bottles, roll the roll so that any wax bubbles can rise to the top.

We check the temperature again, preferably on the inside of the wrist.

Apply the wax at a 45-degree angle, rolling it in the direction of the hair growth..This should be done so that the wax forms a thin layer over the desired area of skin (preferably in a single stroke).The wax spreads well with a wooden spatula, too.

Immediately press the interfacing firmly against the body.

Next, use one hand to stretch the fabric, and with the other, firmly grasp the fabric and, with a quick, vigorous motion (in the opposite direction of the grain), pull the interfacing.Be careful not to peel it up with this motion, but to peel the material off as flat as possible.

To relieve the burning sensation, it's best to immediately press gently with your hand on the area where you removed the hair.It really works well.